Arduino - Led Blink
This is a simple project using Arduino. It would enrich your knowledge about Arduino. You’re going to program your first Arduino project starts with LED. Components required You will need following components - Breadboard x 1 led x 1 ( any color ) 220Ω / 330Ω Resistor x 1 Jumper x 2 ( Male - Male) Arduino Uno x 1 ( Any Arduino board can be used ) Procedure Follow the circuit diagram and hook up the components on the breadboard as shown in the image given below. Connect the positive terminal of the LED to 8th pin in Arduino board after adding resistor to negative terminal of the LED then connect the end of the resistor to GND of the Arduino board. Note − To find out the polarity of an LED, look at it closely. The shorter of the two legs, towards the flat edge of the bulb indicates the negative terminal. Sketch Open the Arduino IDE software on your...